For the best cleaning a patio wicklow company, call Southeast Contractors.
As people explore the possibility of installing a radiant heat system, many compare a staple-up radiant heat system to a Warmboard system. Both have their advantages and disadvantages, but this article will give you some pointers on choosing the correct system for your home.
warmboard, underfloor heating, underfloor heating system, radiant underfloor heating,radiant heat,radiant heating
To find the best cleaning a patio wicklow company, click here for Southeast Contractors.
Many people are confused over the choice between Warmboard and a staple up radiant heating system. This article should help to set you straight.
A Warmboard system combines a structural subfloor with a complex radiant panel into one straightforward radiant heating system. Its basically a strong, broad, weather-resistant, 4′ X 8′ sheet of plywood, with a series of channels cut into the top plane and a thick sheet of high-grade aluminum, which is permanently bonded to each panel. The aluminum is highly conductive. In fact, its about 30% more conductive than most common alloys, but it also cools down quickly.
Warmboard replaces the normal structural subfloor. It can be cut, nailed or screwed directly to your floor joists just like any conventional subfloor.
Most Warmboard systems function with water ranging in temperature between 90 and 110, however if you are considering a wool carpet, or another high resistant floor covering, you can easily raise your water temperatures and still operate your heating system efficiently.
Warmboard also have two important properties – they have high conductivity and low thermal mass, which means they will heat us quickly and retain heat quite well, but not quite as long as radiant systems imbedded in concrete.
In comparison, a staple up radiant heat system is the most unobtrusive radiant heat to install in an existing home. It will not add any additional floor height or disrupt your existing floor coverings as it is installed underneath the current subfloor between the floor joists.
This system is perfect when you want to add a radiant heat system without replacing your floors or floor coverings. For example, if your basement is unfinished you could easily staple up radiant heat tubing between your ceiling, or floor joists.
A staple-up system is not as responsive as the aluminum base method, but is more responsive than the thermal mass method